Shaping the radiator shrouds to fit the body - 1/8" at a time, panel on, panel off.
Laser alignment of the body join - nothing but the best here!
Then there was the very carefully made fibreglass panel to seal around the muffler hangers. But when I installed the leg spats... I found that I couldn't remove and install the panels because of the tight fit around the hangers! Days of work were undone in seconds with a Dremel diamond bit.
Fuel tank sender hole.
Fuel tank heat blankets. Looks like it's been designed by a committee!
An easier solution?
One day!
My Mum and Dad visited and helped build the ECU box and the ignitor pack and MAP sensor panels.
Swiss cheese.
Sublime -> rediculous; Elizabeth's multi-purpose heart of gold Diahatsu to the rescue.
VH-XAA & E's legs.
Proud owner!
When the RotorWay grows up...
No comments:
Post a Comment